Progress Lighting P8617-31 Instruction Manual Page 1

Browse online or download Instruction Manual for Unknown Progress Lighting P8617-31. Progress Lighting P8617-31 Instructions / Assembly User Manual

  • Download
  • Add to my manuals
  • Print
  • Page
    / 4
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 0
12V AC LED Series
Installation Instruction Guide
Please note these warnings:
1. Do not plug-in transformer until the low-voltage cable is installed and the light fixtures are connected. Also, disconnect the transformer
power before any service to the product.
2. Warning: Risk of electrical shock. Do not install light fixtures within 10 feet of pool, spa or fountain.
3. Warning: Risk of electrical shock. Install power unit 5 feet or more from a pool, spa or fountain. Connect power unit to a receptacle
protected by GFCI protected cover plate receptacle marked "Wet location while in use."
4. Install, operate and maintain system to meet all applicable codes.
5. Operate only 12V AC fixtures on this system.
6. Do not attempt to service, adjust or replace any part of the LED light sources.
7. Always do final aiming and fixture spacing at night for best lighting effect.
8. This product contains chemicals known in the state of California to cause cancer, birth defects and/or other reproductive harm.
Thoroughly wash hands after installing, handling, cleaning or otherwise touching this product.
First: P8270 Transformer - Ensure total fixture wattage does not exceed
45
watts. Select transformer mounting location within 30
inches of an 120V, un-switched, GFCI protected outlet. Install mounting screws on 2 5/8 inch centers leaving enough space under the
screw heads to attach the transformer. Strip one end of the low-voltage cable 3/8 inch and separate the leads ½ inch. Push both leads
up into the cable connection point on the bottom and secure with set screws. Hang the transformer on the mounting screws. Install the
photo-control within 40" of the transformer where natural daylight is available. Be careful to aim away from any artificial light source.
Set Transformer Mode:
The P8270 has several operation choices. Off - turns lighting off. On - Lights will burn regardless of
time. Dusk To Dawn - Uses the photo-control to turn lights on at dusk and off at dawn. Timer
Hours - Use if you desire to turn lighting off during the night. Set to the number of "ON" hours you
wish. The photo-control will turn the lighting on when it gets dark and then off when the set number
of hours is reached.
Second: P8617 / P8626 Low-Voltage Cable - Lay the main low-voltage cable along the path
where the light fixtures will be installed. The cable is available in 75ft (P8617) and 150ft (P8626)
lengths.
Third: Place landscape fixtures in the desired locations and connect each to the main low-voltage cable. Place the plastic insert with
curved side down over the main low-voltage cable. While holding these together, slide the plastic insert down the connector guides until
the stainless steel stabs make contact with the low-voltage cable. Tighten the cap, taking care to properly thread, until the cable is
compressed on the stabs. If cable other than #14 is used care must be taken to align cable with stabs. By inverting the plastic insert,
#12 cable can be used.
Page view 0
1 2 3 4

Summary of Contents

Page 1 - 12V AC LED Series

12V AC LED Series Installation Instruction Guide Please note these warnings: 1. Do not plug-in transformer until the low-voltage cable is installe

Page 2 - 93033064 (12/01/10)

Well Light (P5295)Remove from carton. Select mounting location and remove dirt, mulch or deck material so fixture is well seated and will maintai

Page 3

Serie LED 12 voltios CA Guía de instalación Advertencias 1. No enchufe el transformador antes de instalar el cable de baja tensión o antes de c

Page 4 - Guide d’Installation

Série DEL 12 v CA Guide d’Installation Avertissements: 1. Ne pas brancher le transformateur avant d’installer le câble de basse tension ni avan

Comments to this Manuals

No comments