SPEC.NO.
(01-07-09)93003600
Assembly & Installation Instructions
Read instructions carefully and turn electricity off at main
circuit breaker panel before beginning installation.
2621
CAUTION:
PAGE of
1 2
***************************************************************************************************************************************************************
1
2
3
4
5
6
8
7
10
9
12
13
11
14
15
Chien Luen Industries (Zhongshan) Ltd.
should be used only with ceiling fan models:
Net Weight of the light fixture: 2.97 Lbs. (1.35 kgs.).
P2501(52-ANT),P2503(52-RDT), manufactured by
CAUTION - To reduce the risk of fire and electric shock, this light kit
and lamp.
CAUTION - All glass is fragile, use care when handling Glass Shade (1)
***************************************************************************************************************************************************************
16
1, 2, 8 & 9
(NOT FURNISHED)
(NO INCLUIDA)
(NON FOURNIE)
As required by Congress, this fixture contains a device to limit lighting power consumption to 190 watts or less. If the
wattage of installed bulbs exceeds 190 watts, the light fixture will not operate. To reset the limiter (1) turn off power
using the pull switch or wall switch, (2) reduce the total wattage of installed bulbs to less than 190 watts and (3) restore
power to resume normal operation.
This product contains chemicals known to the State of California to cause cancer, birth defects and /or other reproductive
harm. Thoroughly wash hands after installing, handling, cleaning, or otherwise touching this product.
This fixture comes with replaceable ballast. Should the ballast fail; contact a qualified electrician to replace
it. If further assistance is required, contact: Consumer Products Technical Support at: (864) 678-1670.
If any Special Control Devices are used with this Fixture, Follow the Instructions Carefully to assure full compliance with
N.E.C. requirements. If there are any questions, contact a Qualified Electrical Contractor.
WARNING -
WARNING -
WARNING -
NOTE -
1.- Remove the Switch Housing Cover (1) by removing the
three Mounting Screws (2).
2.- Remove the Center Plug from the Switch Housing Cover (1).
3.- Remove the Hexnut (3) and Lockwasher (4) from the Stem (5) of the
Light Kit Fitter (6).
4.- Insert the Light Kit Wires (7) thru the center hole of the Switch
Housing Cover (1) and thread Cover onto the top of the Light Kit
Fitter (6). Replace Lockwasher (4) and Hexnut (3) onto Stem (5) to
secure in place.
5.- Carefully pull down Blue and White Wires from the Switch Housing
(8) (labeled "For Light Kit Connection"). Connect Light Kit Wires (7)
to Switch Housing Wires (9) (Black to Blue and White to White) by
connecting male to female Quick Connects (10). Take care to align
tabs for secure fit.
6.- Align the screw holes of the Swich Housing Cover (1) with the screw
holes of the Switch Housing (8) and secure with the three Screws
(2) removed in step 1.
7.- Install Lamp (16).
8.- Slip Glass Shade (11) over Socket Nipple (12) and seat against
Upper Cap (13). Slip Lower Cap (14) over Nipple (12) and Secure
Cap and Glass by Threading Finial (15) to Nipple (12). (FINGER
TIGHTEN ONLY). Align Holes in Upper Cap (13) and Lower Cap
(14).
9.- Slip Pull Chain from fan through holes.
10.- Attach wood pull tabs to chains.
(2 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals