Progress Lighting P2526-20 Instruction Manual download pdf (Page 11)

8.

Rubber

washer

Blade

arm

Figure 15

Blade

Screws

Attaching the Fan

Blades

Step 1 Attach the blades to the blade arms

using three screws and rubber washers as

shown in Figure 15. Start a screw into the arm,

do not tighten. Repeat for the 2 remaining

screws and washers.

Step 2 Tighten each screw securely starting

with the center screw. Make sure the blade is

straight.

Step 3

(Figure 16)

Step 4 Install an optional light kit if you wish.

Follow the instructions included with the kit.

NOTE: Your fan blades are reversible. Select

the blade side finish which best accentuates

your decor.

Fasten the blade assembly to the motor

using the motor screws provided.

Figure 16

Motor

Blade arm

'

Finishing the

Installation

1. Carefully unhook the fan from the mounting

plate, for Standard Mounting; you can keep the

cable around the hook and seat the hanger ball

in canopy, make sure the tab in the ring at the

bottom of the canopy is properly seated in the

groove in the hanger ball. Align the locking

slots of the ceiling canopy with the two screws

in the mounting plate. Push up to engage the

slots and turn clockwise to lock in place.

Immediately tighten the two mounting screws

firmly.

2. Install the remaining two mounting screws

into the holes in the canopy and tighten firmly.

3. Install the decorative canopy ring by aligning

the ring's slots with the screws in the canopy.

Rotate the ring counter-clockwise to lock in

place.

4. You may now proceed to attaching the fan

blades.

WARNING

LOCKING SLOTS OF CEILING CANOPY

ARE PROVIDED ONLY AS AN AID TO

MOUNTING. DO NOT LEAVE FAN

ASSEMBLY UNATTENDED UNTIL ALL

FOUR CANOPY SCREWS ARE ENGAGED

AND FIRMLY TIGHTENED.

'

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 31 32

Comments to this Manuals

No comments