Progress Lighting P2526-20 Instruction Manual download pdf (Page 9)

6.

Figure 12

Figure 13 Figure 13-1

Close- to-Ceiling

Mounting

Standard Mounting

Installing Fan to the

Electrical Box

The outlet box and support structure must be

securely mounted and capable of reliably

supporting a minimum of 50 pounds. use only

cul listed outlet boxes marked"Acceptable for

Fan Support of 22.7 kgs (50 lbs) or less".

1. Pass the 120-volt supply wires through the

center hole in the ceiling mounting plate as

shown in Figure 11.

2. Install the ceiling mounting plate on the

electrical box by mounting screws provided with

the outlet box. When using close-to-ceiling

mounting, it is important that the mounting plate

be level. If necessary, use leveling washers (not

supplied) between the mounting plate and

electrical box. Note that the flat side of the

mounting plate is toward the electrical box

(Figure 11).

3. Securely tighten the two mounting screws.

4. For additional security, install the wood

screws with flat washers (not included)

through outer slots in mounting plate and

into wooden joist. Note: Leave one wood

screw untightened to attach safety cable

from motor (Figure 12).

5. Carefully lift the fan assembly up to the

ceiling mounting plate and hang the fan on

the hook under the following two ways: for

Close-to-Ceiling Mounting; utilizing one of

the holes at the outer rim of the ceiling

canopy (Figure 13), for Standard Mounting;

place the looped end of the safety cable out

of hanging ball around the hook on the

ceiling mounting plate. (Figure 13-1)

Outlet box

Ceiling

Figure 11

Mounting

screws

(supplied with

electrical box)

Ceiling

mounting

plate

CUL Listed

electrical

box

120V Wires

Washers

Wood joist

WARNING

THE HOOK AS SHOWN IN FIG. 13 IS ONLY TO

BALANCE FAN WHILE CONNECTING

WIRING. FAILURE TO HANG AS SHOWN IN

FIG. 13 MAY RESULT IN HOOK BREAKING

CAUSING THE FAN TO FALL. HOOK MUST

PASS FROM INSIDE TO OUTSIDE OF

CANOPY.

THE ILLUSTRATION SHOWN IN FIGURE 13-1

IS ONLY TO PROVIDE A MEANS TO

BALANCE THE FAN WHILE ATTACHING

WIRING.

FAILURE TO COMPLETE INSTALLATION

ACCORDING TO THIS MANUAL WILL

RESULT IN DAMAGE TO PROPERTY AND

PERSONAL INJURY.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 31 32

Comments to this Manuals

No comments